| 
The ATS800 Series conveyor is designed for applications where
high reliability, cleanliness, ESD control and non-contact
queuing are process requirements. This asynchronous transport
system is ideal for manufacturing environments in the semiconductor,
pharmaceutical, disk drive and flat panel display industries.
Its modular design offers a high level of flexibility for
initial installation as well as for future line changeovers.
An extremely affordable Class 10 clean-room conveyor system,
the ATS800 offers simple and flexible flow controls through
separate localized zone control logic within the conveyor
frame.
- Open-center design maximizes air flow and tool access
(lift & locate dock feature optional)
- Continuous conductive path from pallet to ground
- Easily adjustable sensor positions
- Reflective sensors for reliable pallet detection (optional
through-beam)
- Compact design
- Low-profile aluminum extrusions allow easy installation,
accessibility and "plug-and-play" expandability
- Reliable components
- Fully enclosed drive components
- Individual stepper motor drive
- Easy width adjustment by changing tiebar
- Step-design rollers allow different sized pallets on same
section
- Mounting slots in both drive and idle side extrusions
- Can be mounted on legs or ceiling hangers
- Meets CLass 10 Clean Room standard
- ESD measurement: the mean value of the amount of charge-increase
during a typical handling cycle is -1.01 kV/m. (roller material
dependent)
- Transport speed: up to 220 mm/second
- Maximum workpiece weight: up to 2 kg (over 80 mm length)
- Roller material: proprietary static dissipative plastic
and rubber material, and stainless steel
- EN finishing for metal surface
- Minimum cassette/pallet dimensions: 100 mm long, 25 mm
wide (other dimensions available upon request)
- Quiet, bi-directional motion capability
- Selectable acceleration and deceleration
- Sensor-mediated soft stops repeatable to within +/-4 mm
(speed dependent) from reference point (higher stopping
accuracy achievable with external stopper)
- Low power requirements (24 VDC, AC supply optional)
- Comes standard with onboard local control
- Built-in control board for each zone
- Programmable advanced motion control parameters including
velocity, acceleration and deceleration, indexing steps
and direction
- Portable parameter-programming console
- Optional control via PLC, PC or as slave to adjacent machine
- Standard SMEMA or SECSI/SECSII interface protocol
- Optional control card integrates with standard remote
I/O control/ monitoring, ID reader or RF tag reader at decision
points
- 250 mm
- 500 mm
- 1000 mm
- 1500 mm
- Optional control card integrates with standard remote
I/O control/ monitoring, ID reader or RF tag reader at decision
points
- Rotator (pneumatic or electric)
- Elevator (pneumatic or electric)
|
